Like I do so often, I’m being a bit redundant. While I’m all for stamping out and eliminating redundancy, this is redundancy with a purpose (not a porpoise). Not long ago, in a galaxy not far away, I blogged about annoyances in surface mount diode polarity markings. You can read that here.
Messy isn’t it? Well, after reading that blog, someone asked me about dual diodes. For some reason, I can’t seem to find the page covering dual diodes in my IPC book, but that’s not the important part. What is important is the way the diodes are marked on the PC board.
We do ask for centroid data which, in theory, contains the component rotation. That would be cool except that we find that far too often, the zero degree orientation (and the rotation from that) differs from the standard. That, and there are seemingly half a dozen or so standards.
Since LEDs don’t work too well backwards, we really would like to see everything marked in a non-ambiguous way in silk screen (or in an assembly drawing if you don’t have silk screen). A “cathode bar” won’t work because it could be a bar indicating the cathode or negative. The cathode isn’t always negative, especially when looking at TVS or Zener diodes.
Mimicking the diode markation pattern printed on the part may not be secure either. Read that article I linked to right at the start of this blog. What if you put silkscreen down to match one of those LEDs but ended up buying the other one? That’s exactly what I did myself. Trust me. It just leads to disappointment and possible soldering iron induced finger burns.
So what is the answer, and why am I talking about single LEDs and TVS diodes when the blog is about dual LEDs? Well, the answer is the same. The best way to communicate the desired polarity of an LED or any kind of diode is with a mini version of the schematic symbol. It doesn’t matter if it’s a single LED, dual LED, Schottky, Zener or whatever kind of diode. The schematic symbol is the clearest way to go.
The diode footprint has the manufacturer’s polarity marking, but I don’t care. I still put the diode schematic symbol next to it. If you don’t have room for silk screen, put it in an assembly drawing. You won’t regret it.
And they called him Flipper…