| Master Bond Rolls Out LED401 |
 |
 |
| Written by Chelsey Drysdale | |||
| Friday, 19 October 2012 10:22 | |||
|
Master Bond LED401 adhesive, sealant, coating and encapsulant cures tack-free under exposure to a 405nm wavelength light source, without any oxygen inhibition. Is for applications involving heat-sensitive substrates. Viscosity is 100,000-150,000cps. Has cure times of 15 to 30 sec. or fewer in thinner sections; can be readily cured in sections up to 1/8 in. thick. Offers resistance to water, many acids, bases and oils. Has a volume resistivity exceeding 1014ohm-cm and a temperature range of -60° to +250°F. Has a shelf life of six months at room temperature without exposure to light, in its original containers.
|
Columns
| Semblant Warms to New Fluoroolymer Conformal Coating |
|
Months after hinting at a new conformal coating during a paper session at SMTA International, Semblant has officially launched PlasmaShield. CIRCUITS ASSEMBLY editor in chief Mike Buetow spoke with vice president of worldwide sales and marketing Steve McClure last week. |
| Read more... |
| ECTC in Las Vegas |
What happens in Las Vegas at ECTC, doesn’t stay in Las Vegas, it is shared here. This year’s ECTC, or electronics components technology conference, was held in Las Vegas’ Cosmopolitan, May 28-31. |
| Read more... |
Features
| The Impact of Reel Splicing Kits on Setup and Changeover |
Traditional feeder setup using tape-and-reel can drain time. There’s a quick and better way. |
| Read more... |
| Standard Solar Cells vs. Next-Gen Cells: Which is Winning? |
Overcapacity is stalling the rate of improvement, but only for so long. |
| Read more... |
Search
Search
Login
CB Login
Language
Language
Products
TOM system (Teachable Optical Measurement) inline AOI has been enhanced for inspection of conformal coating Maximum PCB size 460 x 400mm. Can be adjusted to specific test requirements. Range of...
