| KIC Sets up Repair, Calibration Center for Mexico |
 |
 |
 |
| Written by Chelsey Drysdale | |||
| Monday, 17 September 2012 21:58 | |||
|
GUADALAJARA – KIC Thermal has launched a repair and calibration center here to meet increased customer demand. Customers can send profilers and other KIC equipment to the Guadalajara service center, thus bypassing US customs. The new office also means faster turnaround times and less expensive services, the firm says. To use KIC’s service office in Guadalajara, contact Miguel Carbajal at +52 1 33 1605-5094 or e-mail This e-mail address is being protected from spambots. You need JavaScript enabled to view it .
|
Columns
| Semblant Warms to New Fluoroolymer Conformal Coating |
|
Months after hinting at a new conformal coating during a paper session at SMTA International, Semblant has officially launched PlasmaShield. CIRCUITS ASSEMBLY editor in chief Mike Buetow spoke with vice president of worldwide sales and marketing Steve McClure last week. |
| Read more... |
| ECTC in Las Vegas |
What happens in Las Vegas at ECTC, doesn’t stay in Las Vegas, it is shared here. This year’s ECTC, or electronics components technology conference, was held in Las Vegas’ Cosmopolitan, May 28-31. |
| Read more... |
Features
| The Impact of Reel Splicing Kits on Setup and Changeover |
Traditional feeder setup using tape-and-reel can drain time. There’s a quick and better way. |
| Read more... |
| Standard Solar Cells vs. Next-Gen Cells: Which is Winning? |
Overcapacity is stalling the rate of improvement, but only for so long. |
| Read more... |
Search
Search
Login
CB Login
Language
Language
Products
TOM system (Teachable Optical Measurement) inline AOI has been enhanced for inspection of conformal coating Maximum PCB size 460 x 400mm. Can be adjusted to specific test requirements. Range of...
