Soldering excursions can lead to visual process indicators.

This month we look at cracks in plated through-holes around the knee of the hole. FIGURE 1 shows very small via holes that were subjected to multiple lead-free soldering steps, then underwent thermal cycling with no failures but a little cracking.

The cracks visible in the microsection were found on via holes not after the initial two reflow steps and wave-soldering test boards, but after further temperature cycling at -55^o +125^oC. No electrical failures were detected, just the impact of repeated stressing of the copper. It is a good demonstration of how reliable a board can be, but all that stress does have some visual impact. Care must be taken during microsection preparation to see these indicators.

To continue reading, please log in or register using the link in the upper right corner of the page.

• Prev
• Next