caLogo

Products

 
Feinfocus and Xradia announce a new  3-D x-ray inspection technology for the semiconductor packaging and medical device industries.
 
The microXCT defect detection system uses non-destructive 3-D tomography to view the complete structure of advanced packages. Unlike conventional x-ray imaging systems that lose resolution during tomography, this system scans packages in 3-D at full resolution. Multiple resolution modes allow users to switch from navigation at 30µm to high-resolution defect localization and characterization at 1 µm. Automated 3-D tomography features virtual cross-section capability, eliminating the need for sample preparation. Can image and construct a high-resolution 3-D Volumetric dataset with up to 1000 cross-sectional slices in 15min. Has a compact design.
 
FEINFOCUS, .ch
LDC LDC-319 Micro-Probe is a micro size radiometric detector developed for medical and photobiological applications as well as general radiometry.
 
Mmeasures 2.5 x 2.5 x 20 mm, enabling it to operate in remote limited space applications.
In combination with a single or multi-channel optometer, irradiance from 1 nanowatt/cm² to 3 watts/cm² (limited exposures) over a 250 to 1100 nm spectral range can be measured and monitored.
 
Stainless steel housing makes it suitable for medical use; includes a 2.3 x 5 mm RADIN diffuser for cosine corrected measurements.
 
Certification of absolute calibration in watts/cm² at any or all wavelengths between 250 to 1100nm including relative spectral responsivity plot, is supplied for each detector.
 
Gigahertz Optik Inc., gigahertz-optik.com

OmniFlex 10 Reflow Oven is designed to optimize operating efficiencies, reduce maintenance intervals, and lower life-cycle costs.  Said to feature advanced heating and cooling transfer technologies, energy efficient design concepts and reduced maintenance requirements. Up to 50% less power and 35% less nitrogen is required than comparable platforms– due to new designs and features including standard, variable-speed closed-loop blower control, power limiting, balanced gas flow and a dual chamber heating design.
 
Process Width: 508 mm (20"); Heated Length: 3810 mm (148"); Cooling Length: 1285 mm (50.5"); and Maximum Operating Temperature: 350°C (662°F).
 
Electrovert VectraElite wave soldering system features a host of improvements. 
Combines UltraFill nozzles and the upper High Velocity Convection pre-heat (HVC) module.  The ServoJet spray fluxer is coupled with the Performa and Opti-Flux II.  Has a new roll-out solder pot design, and additional enhancements.
 
Speedline Technologies,speedlinetech.com

Page 1867 of 2032

Don't have an account yet? Register Now!

Sign in to your account