Delo-Dot PN3 pneumatic microdispensing valve is said to reduce minimum dispensing amount by a factor of three versus its predecessor, and some products such as unfilled acrylates can be jetted 

permanently in amounts as low as 0.009mg. Optimized fluid system geometry permits a maximum dispensing volume of almost 14mg, to cover a large field of applications. Two different piston types, one for very small dispensing amounts and one for small to medium drop sizes. Both configurations provide an operating frequency of up to 330 drops/sec. Eases handling by means of a rotary wheel, which sets the stroke of the piston by selecting one of five different locking positions without any additional tool. Respective position is indicated by an LED, thus making it easier to check the stroke setting, in particular after integration into a production system. Has no open electric contacts and is screwed onto the valve, which facilitates disassembly for cleaning and maintenance.

Delo Industrial Adhesives, www.delo-adhesives.com

AgIC Pen draws electrical circuits on a sheet of paper. Circuits have the capability to conduct electricity. Tracing connects and transforms different forms in 3D miniatures, such as small paper cities. Creates fully lit scenes.

Kandenko, https://www.kandenko.co.jp/en/

640-35 (dam) and 640-46 (fill) dam and fill UV-cured chip encapsulants, for chip-on-board smart card applications, protect wire bonds and reduce stresses associated with thermal cycling. Cure rapidly when exposed to intense UV light centered at 365nm. Are for encapsulating small chips in smart card applications where fast processing is required. Reportedly withstand circuit board reliability test criteria.

Engineered Material Systems, conductives.com

HighDensity module is for inspecting conformal coatings. This orthogonal camera technology for S3088 CCI inspection system is recommended for inspecting nano-plasma coatings. Can inspect temperature-resistant silicone-based coatings used to make smartphones resistant to moisture. Includes high-power LEDs attached around the camera. Can be additionally equipped with four or eight angled cameras. Is reportedly ideal for silicone or thin coatings.

Viscom, www.viscom.com