Multitest concept, for pressure sensors for MEMS test and calibration equipment, equips a standard test handler with a pressure contact cassette and combines it with the pressure generator. Components can be aligned to meet pressure test requirements. Covers from 0.2 to 20 bars with up to five different pressure levels over a temperature range from -40° to 135°C. Supports absolute pressure tests, as well as relative pressure and leakage tests.
Solder Paste Recycling unit reportedly is able to reduce the amount of waste material to less than 10% of current volumes. Now enables the separation of flux and solder, using a solder pot mechanism that inverts during each cycle. Turns wasted solder paste into solder bar in approx. 34 to 45 min. Max. volume per cycle is approx. 5.5 lb.
ELpF lightweight benchtop vibration isolation system can be repositioned, even with a load and in float. Does not damage vibration isolators. Provides vibration isolation for sensitive devices. Features a load capacity of 100 or 300 lbs. Has a 3" high nominal profile; uses a 16" x 19" standard tabletop, and weighs 40 lbs. Features include gauges tilted upward and recessed handles. For supporting atomic force microscopes, microhardness testers, analytical balances, and other gear in laboratories and Class 100 cleanrooms. Self-leveling and active-air isolation give the platform natural frequencies of 1.75 Hz vertical, 2.0 Hz horizontal, and typical isolation efficiencies of 95% (vertical) and 92% (horizontal) at 10 Hz.
Permabond TA459 magnet adhesive is non-corrosive to electrically conductive surfaces, including copper. Is used with Initiator 43 and is for bonding magnets and metals, achieving 50% of full strength within 15 min. The high-viscosity gel has exceptional shear strength; forms strong bonds to a variety of plated and non-plated surfaces with a resistance to high-temperatures, vibration and impact.
FX-UV automated conformal coating inspection system inspects for coverage, selected areas of non-coverage, delamination, cracks and bubbles. No programming required. Inspection setup reported requires a few minutes. A known good board is used to learn the coverage and non-coverage areas. Inspection typically takes a few seconds, with results immediately displayed. Results can be stored and reviewed off-line at any time. Reads all common barcodes, stores images and inspection results for traceability.
PV InstantSeal 100% silicone reactive hot melt supports high-speed assembly, improving solar frame and junction box sealing. Is a neutral cure sealant that minimizes contamination of module components during assembly. Reportedly has a pot life up to 24 hr. and long overall open time at temperatures less than 125°C.
